BS EN 13445-5:2009 specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2:2009 subject to predominantly non_cyclic operation (i.e. vessels operating below 500 full equivalent pressure cycles).

Special provisions for cyclic operation are given in EN 13445-3:2009 and in Annex G of this Part.

Special provisions for vessels or vessel parts working in the creep range are given in Clause 5, Clause 6, Clause 10, Annex H and Annex I of this Part.

NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 97/23/EC. Guidance on this can be found in CR 13445-7.



Cross References:
EN 287-1:2004
EN 287-1:2004/A2:2005
EN 473:2008
EN 571-1:1997
CEN/TS 764-6:2004
EN 583-4:2002
EN 583-4:2002/A1:2003
EN 895:1995
EN 970:1997
EN 1289:1998
EN 1289:1998/A1:2002
EN 1290:1998
EN 1290:1998/A1:2002
EN 1290:1998/A2:2003
EN 1291:1998
EN 1291:1998/A1:2002
EN 1291:1998/A2:2003
EN 1418:1997
EN 1435:1997
EN 1435:1997/A2:2003
EN 1712:1997
EN 1712:1997/A1:2002
EN 1712:1997/A2:2003
EN 1713:1998
EN 1713:1998/A1:2002
EN 1713:1998/A2:2003
EN 1714:1997
EN 1714:1997/A1:2002
EN 1714:1997/A2:2003
EN 1779:1999
EN 1779:1999/A1:2003
EN 12062:1997
EN 12062:1997/A1:2202
EN 12062:1997/A2:2003
EN 12517-1:2006
EN 13445-1:2009
EN 13445-2:2009
EN 13445-3:2009
EN 13445-4:2009
EN ISO 4063:2000
ISO 4063:1998
EN ISO 5817:2007
ISO 5817:2003
EN ISO 6520-1:2007
ISO 6520-1:2007
EN 1593
EN 13184
EN 13185
EN ISO 17662
ISO 17622:2005
97/23/EC


All current amendments available at time of purchase are included with the purchase of this document.