BS EN 13166:2012+A2:2016 specifies the requirements for factory made phenolic foam products, with or without facings or coatings, which are used for the thermal insulation of buildings. The products are manufactured in the form of boards and laminates.

Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels; the performance of systems incorporating these products is not covered.

This standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling.

This standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.

Products with a declared thermal resistance lower than 0,40 m^2.K/W or a declared thermal conductivity greater than 0,050 W/(m.K) at 10 °C are not covered by this standard.

This standard does not cover in-situ thermal insulation products, products intended to be used for the thermal insulation of building equipment and industrial installations (covered by EN 14314 [3]).


Cross References:
EN 822
EN 823
EN 824
EN 825
EN 826
EN 1602
EN 1603
EN 1604
EN 1606
EN 1607
EN 1609
EN 12086:1997
EN 12087
EN 12089:1997
EN 12429
EN 12667:2001
EN 12939
EN 13172:2012
EN 13501-1
EN 13820
EN 13823
EN 15715:2009
EN ISO 1182
ISO 1182
EN ISO 1716
ISO 1716
EN ISO 4590
ISO 4590
EN ISO 9229:2007
ISO 9229:2007
EN ISO 11925-2
ISO 11925-2
ISO 16269-6:2005
ASTM D 3985
EN 12090
EN 14314
EN ISO 10456
ISO 10456


Incorporates the following:
Amendment, April 2015. Amends and replaces BS EN 13166:2012. Amendment, June 2016. Amends and replaces BS EN 13166:2012+A1:2015