This document specifies the technical delivery conditions for two test categories of electric welded and submerged arc longitudinally (SAWL) or helically (SAWH) welded tubes of circular cross section, made from weldable fine grain steel.

NOTE 1 These tube grades are intended to support the essential requirements of EU Directive 2014/68/EU in respect of pressure equipment covered under all relevant Categories as set out in Article 13 of that Directive.

NOTE 2 Once this standard is published in the Official Journal of the European Union (OJEU), presumption of conformity to the Essential Safety Requirements (ESR) of Directive 2014/68/EU is limited to the technical data for the materials in this standard and does not presume adequacy of the material for a specific item of pressure equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of a specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done by the designer or manufacturer of the pressure equipment, taking also into account any subsequent processing procedures which may affect properties of the base materials.

Cross References:
CEN/TR 10261
EN ISO 377:2017
EN 10027-1
EN ISO 17639:2013
EN ISO 2566-1:1999
EN ISO 14174:2012
EN ISO 6892-2:2018
EN ISO 10893-6:2011
EN ISO 10893-1:2011
EN 10020
EN ISO 8496:2013
EN ISO 148-1:2016
EN ISO 8495:2013
EN 10168:2004
EN 10021:2006
ISO 11484:2009
EN 10204:2004
EN 10027-2
EN ISO 5173:2010
EN 10266
EN ISO 6892-1:2016
EN ISO 10893-3:2011
EN ISO 10893-8:2011
EN 10220
EN ISO 4885
EN ISO 8493:2004
EN ISO 643:2012
EN ISO 10893-7:2011
EN ISO 10893-11:2011
EN ISO 10893-10:2011
EN ISO 10893-9:2011
EN ISO 8492:2013
EN ISO 10893-2:2011
EN ISO 14284
EN ISO 9712


All current amendments available at time of purchase are included with the purchase of this document.