This document specifies requirements and test methods for factory made thermally insulated bonded fitting assemblies for hot water networks in accordance with EN 13941-1, comprising a steel service fitting, rigid polyurethane foam thermal insulation and a casing of polyethylene.

The fitting assembly could also include the following additional elements: measuring wires, spacers and diffusion barriers.

This document covers the following fitting assemblies: bend, tee, reducer, single use compensator and anchor.

This document applies to fitting assemblies with a minimum design pressure of 1,6 MPa (overpressure).

Cross References:
EN ISO 17638
EN 12814-1
EN ISO 5579
EN 10253-2
EN 14870-1
EN ISO 5817
EN ISO 15607
EN ISO 3452-1
EN ISO 9606-1
EN ISO 14732
EN ISO 9692-1:2013
EN ISO 8501-1
EN ISO 17637
EN ISO 11666
EN 253
EN 17248
EN 10217-2
EN ISO 23278
ISO 6761
EN ISO 10675-1
EN ISO 23277
EN ISO 17640
EN 10217-5
EN 13941-1
EN 14419
EN 10216-2
EN ISO 17636-1
EN ISO 17636-2
EN 13018
EN 13941-2
EN 10204
EN ISO 16810
EN ISO 9934-1
EN 489-1
EN 15698-1
ISO 2859-2
EN ISO 9001
EN ISO 2553
EN 15698-2
EN 488
EN 15632 (all parts)


All current amendments available at time of purchase are included with the purchase of this document.