Language:
    • Available Formats
    • Options
    • Availability
    • Priced From ( in USD )
    • Printed Edition
    • Ships in 1-2 business days
    • $75.00
    • Add to Cart
    • Printed Edition + PDF
    • Immediate download
    • $101.00
    • Add to Cart

Customers Who Bought This Also Bought

 

About This Item

 

Full Description

1.1 This practice describes a procedure to qualitatively describe the nature of banded or oriented microstructures based on the morphological appearance of the microstructure.

1.2 This practice describes stereological procedures for quantitative measurement of the degree of microstructural banding or orientation.

Note 1: Although stereological measurement methods are used to assess the degree of banding or alignment, the measurements are only made on planes parallel to the deformation direction (that is, a longitudinal plane) and the three-dimensional characteristics of the banding or alignment are not evaluated.

1.3 This practice describes a microindentation hardness test procedure for assessing the magnitude of the hardness differences present in banded heat-treated steels. For fully martensitic carbon and alloy steels (0.10-0.65 %C), in the as-quenched condition, the carbon content of the matrix and segregate may be estimated from the microindentation hardness values.

1.4 This practice does not cover chemical analytical methods for evaluating banded structures.

1.5 This practice deals only with the recommended test methods and nothing in it should be construed as defining or establishing limits of acceptability.

1.6 The measured values are stated in SI units, which are regarded as standard. Equivalent inch-pound values, when listed, are in parentheses and may be approximate.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 

Document History

  1. ASTM E1268-19

    👀currently
    viewing


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Most Recent
  2. ASTM E1268-18


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Historical Version
  3. ASTM E1268-01(2016)


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Historical Version
  4. ASTM E1268-01(2007)


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Historical Version
  5. ASTM E1268-01


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Historical Version
  6. ASTM E1268-99


    Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    • Historical Version