This guide provides information on construction of radiated emission test facilities in the frequency range of 30 MHz to 40 GHz. Standardized site validation methods above 18 GHz remain unavailable at present, however the changes in this edition are considered appropriate guidance for use up to 40 GHz. In general, the construction techniques described apply either below 1 GHz, or for 1 GHz and above. This guide does not address construction code compliance issues. Parties responsible for the design and construction of test sites are advised to consult with the various authorities having jurisdiction (AHJ) to determine the building, HVAC, plumbing, electrical, etc., codes and regulations that are applicable for the test site. In addition, beyond the similarity of basic principles, this guide also does not specifically address considerations on construction of test sites used for calibration of antennas used in EMC radiated emissions measurements; that topic is covered in ANSI C63.5.1,2 In addition, site-dependent measurement instrumentation and signal cabling issues are not in the scope of this guide.