BS EN 61000-6-3:2007 for EMC emission requirements applies to electrical and electronic apparatus intended for use in residential, commercial and light-industrial environments.

Emission requirements in the frequency range 0 Hz to 400 GHz are covered. No measurement needs to be performed at frequencies where no requirement is specified.

BS EN 61000-6-3:2007 is applicable if no relevant dedicated product or productfamily EMC emission standard exists.

BS EN 61000-6-3:2007 applies to apparatus intended to be directly connected to a low-voltage public mains network or connected to a dedicated DC source, which is intended to interface between the apparatus and the low-voltage public mains network.

BS EN 61000-6-3:2007 applies also to apparatus which is battery operated or is powered by a non-public, but non-industrial, lowvoltage power distribution system if this apparatus is intended to be used in the locations described below.

The environments encompassed by this standard are residential, commercial and lightindustrial locations, both indoor and outdoor. The following list, although not comprehensive, gives an indication of locations that are included:

- residential properties, for example houses, apartments;

- retail outlets, for example shops, supermarkets;

- business premises, for example offices, banks;

- areas of public entertainment, for example cinemas, public bars, dance halls;

- outdoor locations, for example petrol stations, car parks, amusement and sports centres;

- light-industrial locations, for example workshops, laboratories, service centres.

Locations that are characterised by being supplied directly at low voltage from the public mains network are considered to be residential, commercial or light-industrial.

BS EN 61000-6-3:2007 is to define the emission test requirements for apparatus defined in the scope in relation to continuous and transient, conducted and radiated disturbances.

The emission requirements have been selected so as to ensure that disturbances generated by apparatus operating normally in residential, commercial and light-industrial locations do not exceed a level which could prevent other apparatus from operating as intended. Fault conditions of apparatus are not taken into account. Not all disturbance phenomena have been included for testing purposes in this standard but only those considered as relevant for the equipment covered by this standard. These requirements represent essential electromagnetic compatibility emission requirements.

Requirements are specified for each port considered.

NOTE 1 Safety considerations are not covered by this standard.

NOTE 2 In special cases, situations will arise where the levels specified in this standard will not offer adequate protection; for example where a sensitive receiver is used in close proximity to an apparatus. In these instances, special mitigation measures may have to be employed.

NOTE 3 As the requirements in this standard are more stringent than the requirements in IEC 61000-6-4, equipment fulfilling the requirements of this standard will also comply with the requirements of IEC 61000-6-4.



Cross References:
IEC 61000-3-2-1
IEC 61000-3-3-1
IEC 61000-3-11-1
IEC 61000-3-12-1
CISPR 14-1-1
CISPR 16-1-2:2003
CISPR 16-2-1:2003
CISPR 16-2-3
CISPR 16-4-2
CISPR 22
EN 61000-3-2:2006
EN 61000-3-3:1995
EN 61000-3-3:1995/Corrigendum:1997
EN 61000-3-11:2000
EN 61000-3-12:2005
EN 55014-1:2006
EN 55016-1-2:2004
EN 55016-2-1:2004
EN 55016-2-3:2006
EN 55016-4-2:2004
EN 55022:2006
IEC 60050-161:1990
IEC 60050-601:1985
IEC 61000-6-1
IEC 61000-6-4
EN 61000-6-1:2007
EN 61000-6-4:2007
89/336/EEC
2004/108/EC


Replaces BS EN 61000-6-3:2001 which remains current.