BS EN 50288-9-2:2015 covers screened cables, characterised from 1 MHz up to 1 000 MHz, to be used to construct cords for use in cabling specified in the EN 50173 series of standards.

The premises-specific cabling standards of the EN 50173 series reference the D1 requirements of this specification for the cable used within cords of the "reference implementations" of those standards. The alternative D2 requirements of this specification may be used to produce cords for other implementations and applications including the direct connection of equipment in data centres.

This sectional specification contains the electrical, mechanical, transmission and environmental performance characteristics and requirement of the cables when tested in accordance with the referenced test methods.

This sectional specification should be read in conjunction with EN 50288-1, which contains the essential provisions for its application.

The cables covered in this sectional specification are intended to operate with voltages and currents normally encountered in communication systems. These cables are not intended to be used in conjunction with low impedance sources, for example, the electric power supplies of public utility mains.


Cross References:
EN 50288-1:2013
EN 50289-3-2
EN 50289-3-4
EN 50289-3-5
EN 50289-3-6
EN 50289-3-8
EN 50289-3-9:2001
EN 50289-3-16
EN 50289-4-6
EN 50290-2
EN 60708
IEC 60708
IEC 60189-2


All current amendments available at time of purchase are included with the purchase of this document.