BS EN 10029:2010 specifies tolerances on dimensions and shape for hot-rolled non-alloy and alloy steel plates with the following characteristics:

a) Nominal thickness: 3 mm less than or equal to t less than or equal to 400 mm; b) Nominal width: w greater than or equal to 600 mm. Tolerances for products of width w less than 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.

BS EN 10029:2010 applies, but is not limited, to steel grades defined in EN 10025-2 to EN 10025-6:2004+A1:2009, EN 10028-2 to EN 10028-6, EN 10083-2 and EN 10083-3, EN 10084, EN 10085, EN 10149-2 and EN 10149-3, EN 10207 and EN 10225 (see also Annex A). It does not apply to stainless steels.

BS EN 10029:2010 does not include round plates, custom-made plates, chequer or bulb plate for flooring and wide flats.



Cross References:
EN 10079
EN 10163-1
EN 10163-2
EN 10025-2
EN 10025-3
EN 10025-4
EN 10025-5
EN 10025-6:2004+A1:2009
EN 10028-2
EN 10028-3
EN 10028-4
EN 10028-5
EN 10028-6
EN 10083-2
EN 10083-3
EN 10084
EN 10085
EN 10149-2
EN 10149-3
EN 10207
EN 10225


All current amendments available at time of purchase are included with the purchase of this document.