1.1 These test methods determine the ability of sliding door assemblies to restrain, delay, or frustrate forced entry.

1.2 For purposes of these test methods, sliding door assemblies are defined as described in and as shown in . Sliding door assemblies with a combination of operable panels and fixed panels (lites) shall be classified and tested separately for each type.

1.2.1 Type AA sliding door assembly which incorporates one or more sliding panels that lock to the jamb.

1.2.2 Type BA sliding door assembly which incorporates one or more sliding panels that lock to an intermediate jamb.

1.2.3 Type CA sliding door assembly which incorporates one or more sliding panels that abut and lock to other panels.

1.2.4 Type DA sliding door assembly which incorporates one or more fixed or stationary panels that are designed not to open.

Note 1 - See for graphic depiction of sliding door assembly types.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.