1.1 This specification covers silver-coated, soft or annealed, round copper wire, intended for use in electrical equipment, as follows:

1.1.1 Class AWire whose silver coating is at least 1.25 % of the total weight of the coated wire.

1.1.2 Class BWire whose silver coating is at least 2.50 % of the total weight of the coated wire.

1.1.3 Class CWire whose silver coating is at least 4.00 % of the total weight of the coated wire.

1.1.4 Class DWire whose silver coating is at least 6.10 % of the total weight of the coated wire.

1.1.5 Class EWire whose silver coating is at least 10.00 % of the total weight of the coated wire.

1.2 Silver-coated wire having different minimum percentages of silver by weight may be obtained by mutual agreement between the manufacturer and the purchaser. For information purposes the thickness of coating in microinches provided by the percentages listed above is shown in (Explanatory Note 1).

1.3 The SI values of resistance and density are to be regarded as standard. For all other properties values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

1.4 The following precautionary caveat pertains only to the test method section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see 8.4.1.2 and Explanatory Note 1.